The complete Autoglym Polar collection is now available in smaller size set, which is a perfect compact introduction into the world of flawless finishing. Be warned - your car will look AMAZING after use!

Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
POLAR BLAST: First product to use is Polar Blast as a snow foam pre wash. Polar Blast can be used at various dilutions depending on the density of foam desired. A good starting point is 100ml product to 500ml water in your foaming bottle. Adjust foam gun settings as required to increase or reduce foam. Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels.
Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it to dry on.
Rinse thoroughly from the bottom up.
POLAR WASH: Second product to use is Polar Wash. Polar Wash can be used at various dilutions depending on the density of foam desired. However, we would not recommend using a dilution stronger than 50% Polar Wash, 50% water. Adjust foam gun settings as required to increase or reduce foam. 250ml of mixed solution should be enough to cover an average sized car. Spray Polar Wash onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels. The cleaner will begin to loosen dirt on all surfaces.
For the most thorough agitate the foam with a sponge or wash mitt. Rinse thoroughly from the bottom up and leave the body work wet.
POLAR SEAL: The final product to use is Polar Seal. Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the final finish. Spray Polar Seal onto the clean, wet vehicle, ensuring all exterior surfaces are covered, although avoid direct application to the windscreen.
Thoroughly rinse then dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a drying cloth and not allowed to air dry as water spotting may occur and dull the overall finish.

€10.99

Delivery Only

In stock

Dispatch: MONDAY

OE Number

Overview

Triple USB-A 3A 15.5W 12/24V Car Charger

Customers who bought this Product also bought:

Safety and Product Information