How to use this product:

Before you start, check that the bodywork and wheels are cool to the touch and out of direct sunlight.
Polar Blast can be used at various dilutions depending on the density of foam desired. A good starting point is 100ml product to 500ml water in your foaming bottle. Adjust foam gun settings as required to increase or reduce foam.
Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels.
Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it dry on.
Finally, rinse thoroughly from the bottom up.

FAQs

What is Polar Blast?

Is Polar Blast pH Neutral?

Do I use Polar Blast instead of shampoo?

Should I agitate the foam generated by Polar Blast?

What is the recommended Dilution rate for Polar Blast?

Can I use this product in a bucket and not a pressure Washer?

polestar 5 parts